OB Cues Ladies
     9-Ball Tour

OB-1 Cue Shaft Construction

Building the OB-1 cue shaft is a unique process in its own. Obviously, the shaft differs from other shafts out there so the construction methods are also different.

The OB-1 starts as flat laminated “Hard Rock Maple” boards. These boards
are then cut into strips, six of which will be used for each shaft. Two of these strips are shown below.

These “Strips” are then turned between centers in order to “stress relieve”
them. This step helps to ensure the shaft is straight, and stays straight.

The strips are then machined to allow them to be joined together into a bundle of six pieces.
The bundle is glued up and put in a clamp to ensure complete glue coverage and no voids or gaps.
The “Blank” comes out of the clamp ready to be made into a shaft.
The ferrule is made from flat laminated “Hard Rock Maple”. The laminations are arranged so that the grain is “clocked” 45 degrees with each layer. The ferrules are made in a block that is then machined into the individual ferrules.

All that is left is to apply the finish and tip. We now use as our standard tip, the Everest tip by Tiger at no additional charge.

See our Products Page for a complete listing of all the OB-1 Cue shafts available as well as pricing and specifications.